Posted by Old ASE Pro on April 10, 03 at 14:32:41:
In Reply to: Mounting 7 pin on factory bumper posted by Old ASE Pro on April 10, 03 at 14:26:48:
Old, fat fingers! It is not "kit" but meant to be "fit". Also, these bits produce the absolute cleanest cut in sheetmetal and are the best way to punch through the firewall! Holes have no burrs so grommets pop in easily. Kent-Moore makes them for the General too, but they charge too much so most dealers buy from Greenlee.
: Pros use a stepper drillbit. It will enlarge the hole with little effort. These are made by Greenlee, and can be bought or rented from electrical supply houses. The part number on my 7/8-inch to 1 3/8-inch Greenlee Kwik Stepper is 36414 and will work perfectly to kit the body of a typical Pollak or Bargman 7-wire RV receptacle.